- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
RD5200 Replicating to RD516
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
RD5200 Replicating to RD516
Hi all
Hoping someone can help me with this, for the past two years i have been replicating my luns on the rd5200 to my rd516, the 5200 is in work and the 516 is at home, everything has been working fine until a few weeks ago, the jobs over the few days started to fail with the staus of broken and the error Job reseed is prohibited, i would delete the replication job and setup again and after the ininitial synch the job would break again, thinking it was an internet connection issue i moved the rd516 back into work attached the network and repeated, the jobs obvisoulsy run a lot faster but the same issue is happening, any advice.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RD5200 Replicating to RD516
The rd5200 is running 1.4.4 and the rd516 is running 1.4.3
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RD5200 Replicating to RD516
Well it could be a good idea to get both onto the same firmware revision 1.4.5. Another advantage of this is that if a disk fails out of warranty depending on the disk type you may be able to replace it with an unsigned disk.