Netgear N600 WNDR3400v3

[Dane_B]

I want to use a WNDR3400v3 as Repeater for an existend Arris_Kabel-TV_Modem_Wlan-Router.

I need the Wlan Signal at the Place where the Arris is placed, also I need the Wlan Signal where the WNDR3400v3 is placed, and this in the same Network.

Can anybody help me?

Thanks

P.s.: I hope you understand what i mean (my english is not the best...)

[Dane_B · Accepted solution]

I do have a Cable between AP and router.

I tried vor some hours, but if I set AP-Mode on WNDR3400v3 its just the W-Lan working and not the ports for the fix cabeld stuff.

so I put the DHCP on again, I set the W-Lan settings at the same as they are on the Router.

and now it is all working in one network.

Thanks for all your help.

[Retired_Member]

Repeater mode doesn't seem to be available on this router. If it was I would think that option would be listed in the manual.

[Dane_B]

Ok so the guy in the shop, sold me the wrong thing...

do you know an produkt i could use?

[Retired_Member]

Assuming you what to improve/add WIFI coverage?  How would you connect to main router? If you have Catxx cable you could use almost any router in AP Mode or as a AP But, this requires a cable connection between AP and router.

[Dane_B · Accepted solution]

I do have a Cable between AP and router.

I tried vor some hours, but if I set AP-Mode on WNDR3400v3 its just the W-Lan working and not the ports for the fix cabeld stuff.

so I put the DHCP on again, I set the W-Lan settings at the same as they are on the Router.

and now it is all working in one network.

Thanks for all your help.

[Dane_B]

I forgot to wrote two points:

i set an fix IP-Adress at the Arris Router.

on the WNDR3400v3 I had to set the AP-Mode off.