VLAN not broadcasting - BR200

[rogermiranda100]

I am connecting two devices (TX and RX) to the same VLAN (VLAN 2) with my BR-200 following this schematic:

Both TX and RX uses group broadcast (over 224.0.0.0/8), but they doesn't read eachother's signals.

I believe that the problem lies on the router configuration, because C1 can read TX's broadcasts, and C2 can read RX's ones.

These are the traffic rules:

The switches are VLAN-capable, and they tag TX, C1, C2 and RX as VLAN 2.

[rogermiranda100 · Accepted solution]

OK, the problem was that C2's switch had enabled (under the 'multicast' option) 'Block Unknown Multicast Address'.

[rogermiranda100 · Accepted solution]

OK, the problem was that C2's switch had enabled (under the 'multicast' option) 'Block Unknown Multicast Address'.

[michaelkenward]

For future reference, the BR200 is better discussed here:

WLAN für Business - NETGEAR Communities

and

Insight Network Management Forum - NETGEAR Communities