× NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Orbi WiFi 7 RBE973
Reply

Can't set Interface IP on Management VLAN - S3300

Retired_Member
Not applicable

Can't set Interface IP on Management VLAN - S3300

Hi,

Every time I try to set the IP address for VLAN 100 (Management VLAN) I get an error; Error! Failed to Set 'IP Address' with '10.41.1.1'. It'll then proceed to create an interface IP of 0.0.0.0 and Subnet Mask of 0.0.0.0.

 

I set this up on the switch (S3300) in the following location; Routing > VLAN > VLAN Routing.

 

Routing is set to enabled in Routing > IP Configuration.

 

Any idea why I can't get thsi working?

Model: S3300-28X (GS728TX)|ProSafe 24 ports stackable smart switches
Message 1 of 2

Accepted Solutions
JohnC_V
NETGEAR Moderator

Re: Can't set Interface IP on Management VLAN - S3300

Hi LAB77,

 

If you are going to assign an IP to your management VLAN. It should be on System > Management > IP Configuration then set it to Static IP Address. VLAN Routing is used to allow more than one physical port to reside on the same subnet.

 

You may check the manual here(page 48).

 

Regards,

 

JohnCarloV

NETGEAR Community Team

View solution in original post

Message 2 of 2

All Replies
JohnC_V
NETGEAR Moderator

Re: Can't set Interface IP on Management VLAN - S3300

Hi LAB77,

 

If you are going to assign an IP to your management VLAN. It should be on System > Management > IP Configuration then set it to Static IP Address. VLAN Routing is used to allow more than one physical port to reside on the same subnet.

 

You may check the manual here(page 48).

 

Regards,

 

JohnCarloV

NETGEAR Community Team

Message 2 of 2
Top Contributors
Discussion stats
  • 1 reply
  • 2782 views
  • 1 kudo
  • 2 in conversation
Announcements