- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Change MTU size on XS728T
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The manual says I can change the MTU size, but I dont see (in the GUI) the setting to change at Switching > Ports > Port Configuration.
Model Name XS728T Boot Version 1.0.0.0 Software Version 6.5.1.30
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi gcarson,
Welcome to NETGEAR community!
The L2 Jumbo Frames size cannot be changed for XS728T, which default value should be 10240 byte frame size under Switching.
But the L3 ipv4 MTU can be changed under Routing>IP>IP Configuration, the default value is 1500.
Regards,
NETGEAR Employee
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi gcarson,
Welcome to NETGEAR community!
The L2 Jumbo Frames size cannot be changed for XS728T, which default value should be 10240 byte frame size under Switching.
But the L3 ipv4 MTU can be changed under Routing>IP>IP Configuration, the default value is 1500.
Regards,
NETGEAR Employee