- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: GSS116E blinking on every port constantly
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
The switch is blinking on every port constantly. It is not possible to get a connection to the switch over the network.
Just after switch on everything seems to be ok, bo only for about a few seconds.
I have disconnected the switch from the network and reset it, but still the problem persist.
Is it typical problem for this model?
Is there any way to repair it on my own?
I will be grateful for your help.
Kind regards
A.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @ReadyAS,
There is no option to download logs from the GSS116E switch. If ever the problem happens again, I suggest you to re-upload the same firmware v1.0.0.6 to the GSS116E switch then reset it back to factory defaults settings. Afterwards, reconfigure the settings from scratch and observe if the same problem occurs.
You can download firmware v1.0.0.6 here.
Regards,
DaneA
NETGEAR Community Team
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: GSS116E blinking on every port constantly
Could it be a problem related with any capacitor? In power supply for instance?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: GSS116E blinking on every port constantly
Yestarday I reseted the switch, waited same minutes after switch-off, switched-on again and the problem persist. I tryied a few times to run the switch.
Today after switch-on the switch works fine (20 minutes for now, but it works fine).
Very nice, but it is strange and I do not have confidence it will work.
How do you think, is this switch good or not?
Maybe that kind of problem sometimes happens in this switch?
I do not see any logs. Is there any way do check what happened?
The firrmware is the newest - v1.0.0.6.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @ReadyAS,
There is no option to download logs from the GSS116E switch. If ever the problem happens again, I suggest you to re-upload the same firmware v1.0.0.6 to the GSS116E switch then reset it back to factory defaults settings. Afterwards, reconfigure the settings from scratch and observe if the same problem occurs.
You can download firmware v1.0.0.6 here.
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content