VLAN Trunking and Web Management not responding
So, pretty frustrated with VLAN Trunking setup on these Netgears. I have 3 locations (A->B<-C), A (716T) and C (716T) connect to (Trunk ports) B (M4300-8x8) and can connect to each other through B. I have 3 VLANs : 10 LAN, 200 VOIP, 30 WIFI. VLAN 10 and 30 are working but VLAN 200 isn't live yet while dealing with our VOIP provider. This setup went live and everything looked great until a week later when I went to login to one of the switches to start working on the VOIP side of things and the Web management interface just hangs. The management VLAN is 10 and again was working fine after the initial install. All 3 of the switches have the same behavior: VLANs 10 and 30 are working across the trunk port, they answer pings, but cannot bring up the web interface. Hopefully someone has some ideas? I can post whatever info you need. All 3 switches were updated to the latest firmware before being deployed. The M4300-8x8 has a console port and OOB port and neither of those are responding either?
Re: VLAN Trunking and Web Management not responding
Welcome to our community!
Once you change the management VLAN to VLAN 10. You should have some ports assigned to be a member of VLAN 10 - U with a PVID 10. If you didn't change the PVID on the port and you didn't enable the ip routing on the management VLAN definitely the admin page will not appear. It seems that you can still ping the switches that means that they just works fine. The only way that we can access the switch is via console.
You may check the M4300 manual for reference(page 633).