Reply

JGS524PE Port-Based VLAN Settings Change

adit
Mentor

JGS524PE Port-Based VLAN Settings Change

Running the current 2.6.0.43 firmware the switch loses/changes a Port-Based VLAN from VLAN1 to VLAN2.

 

It also did this on 2.6.0.35, and the shipping firmware (don't recall what it was).

 

I've tried reinstalling the firmwares followed by a factory default, and it still happens.

 

I have another one of these switches that does the same thing, but usually port 13.  Same procedure, same firmwares.

 

I think this occurs after a power outage.  It doesn't happen after every power outage though.

 

Anyone else seen this?  Firmware problem? 

 

 

 

Model: JGS524PE|ProSafe Plus 24 ports switch with PoE
Message 1 of 2
DaneA
NETGEAR Moderator

Re: JGS524PE Port-Based VLAN Settings Change

@adit,

 

Good day! Smiley Happy  I suggest that you open a support ticket with NETGEAR Support here at anytime.  Kindly state your observations and this might get escalated to the higher tier of NETGEAR Support.  

 

 

Regards,

 

DaneA

NETGEAR Community Team

Message 2 of 2
Top Contributors
Discussion stats
  • 1 reply
  • 319 views
  • 0 kudos
  • 2 in conversation
Announcements