This topic has been marked solved and closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
New installed switch to replaced old version, have set up static IP address to switch and all other network devices by way or cisco rvs4000 router, switch has a static IP address, submask & gateway setup, label port config and enable ports. Problem is, after some time the first three ports seem to disable thenselves, that is lights not lit as well. I need to remove intranet cable from port 1 and connect to port 4 to address the switch and enable ports again, why and thanks
seems no one has an answer, tho many have viewed, not many users have a smart switch in use. would have hope someone from netgear would have responded, maybe being a holiday will need to wait a few days. the switch for now seems to be working, but there is always a bug in the works
Thanks, thought this was a Netgear Support Source, will review the firmware update before downloading, have review any pass issues- no results of my problem- devices has been working correctly for some time now since I started from the beginning once more yesterday- hoping this device will continue to work as needed.
