- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
NMS300 1.7.0.1
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
NMS300 1.7.0.1
Hi.
NMS300 1.7.0.1 + 3x GS748Tv5 FW: 6.3.1.36 + GS724Tv4 FW: 6.3.1.36. Backup of SW configuration not working, passwords are correct. I got errors:
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: NMS300 1.7.0.1
On what Operating System is the NMS300 installed?
Did you just newly update the NMS300 to v1.7.0.1? If yes, is everything working fine before you did the update?
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: NMS300 1.7.0.1
NMS 1.6.0.27 same situation. I think the problem is in firmware 6.3.1.36
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: NMS300 1.7.0.1
On what Operating System is the NMS300 installed?
Let's try this. Kindly try to uninstall then reinstall the NMS300 in your PC. Then, check if the same problem will occur.
If ever the same problem occurred, I suggest you to open a support ticket with NETGEAR Support here at anytime for further investigation.
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: NMS300 1.7.0.1
Windows 2012 R2 Foundation. Reinstallation didn't worked. Support contacted.