- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
S3300 stack firmware
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
i have 2 switch S3300 on a stack.
Firmware are older : 6.4.0.19
i would add a switch in this stack but firmware is more recent than on the stack : 6.6.0.14
On this Switch Image 1 : 6.6.0.14 and image 2 : 6.4.019
do you know if i can add switch with different firmware in a stack ( i think no, but maybe possible) ? or it's possible to boot on image2 ?
regards
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome to our community! 🙂
Yes, you can add a switch on a different firmware but it will also be updated by the master switch. To avoid any problems, the best practice is to add the switch with the same firmware of the stack.
Regards,
John
NETGEAR Community Team
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome to our community! 🙂
Yes, you can add a switch on a different firmware but it will also be updated by the master switch. To avoid any problems, the best practice is to add the switch with the same firmware of the stack.
Regards,
John
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content