Reply
Highlighted
Aspirant
Aspirant

XS708Ev2: unable to remove LAG ID 1 through Web interface

I configured LAG 1 for Port 1-2. LAG 2 for Port 3-4 and LAG 3 for Port 5-6.

 

After restructuring the entire network, the LAGs are not needed anymore. I can delete LAG ID 2 and LAG ID 3 port memberships.

 

LAG1 cannot be deleted and shows error "A LAG must have at least 2 port members!".

 

I'm using firmware V1.0.0.15.

please advice, how to proceed.

 

Model: XS708Ev2|ProSAFE 8-port 10-Gigabit Ethernet Web Managed Switch
Message 1 of 4

Accepted Solutions
Highlighted
Aspirant
Aspirant

Re: XS708Ev2: unable to remove LAG ID 1 through Web interface

Ahhhrg, got it: "admin mode" must be deactivated first.

View solution in original post

Message 4 of 4

All Replies
Highlighted
NETGEAR Moderator

Re: XS708Ev2: unable to remove LAG ID 1 through Web interface

On the admin page, go to System - LAG - LAG Configuration. Disable LAG 1. Then can remove the ports from the LAG.

Message 2 of 4
Highlighted
Aspirant
Aspirant

Re: XS708Ev2: unable to remove LAG ID 1 through Web interface

Thank you for your reply.

please direct me to this button. My view to LAG Configuration:

 Netgear LAG Configuration.JPG

Message 3 of 4
Highlighted
Aspirant
Aspirant

Re: XS708Ev2: unable to remove LAG ID 1 through Web interface

Ahhhrg, got it: "admin mode" must be deactivated first.

View solution in original post

Message 4 of 4
Top Contributors
Discussion stats
  • 3 replies
  • 1330 views
  • 0 kudos
  • 2 in conversation
Announcements