Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
switch status config mismatch
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2021-11-22
07:54 AM
2021-11-22
07:54 AM
switch status config mismatch
Added a switch to our reconfigured stack
the switch that used to be in position 4 was an s3300 28x
The one in that position now is an s3300 52x
the stack is reporting a config mismatch
It shows that the preconfigured model identifier is a 28x and the attached is a 52x
How do I rectify this?
Model: S3300-52X (GS752TX)|ProSafe 48 ports stackable smart switches
Message 1 of 2
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2021-11-24
08:25 AM
2021-11-24
08:25 AM
Re: switch status config mismatch
Welcome to our community! 🙂
Please make sure that the firmware version of the switch that you are trying to add has the same firmware from the switch on the stack. You may also try to reboot all the switches to re-elect the master.
Regards,
John
NETGEAR Community Team
Message 2 of 2