- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
GSS116E will not boot after upgrade from firmware version 1.0.0.2 to 1.0.0.5.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
GSS116E will not boot after upgrade from firmware version 1.0.0.2 to 1.0.0.5.
GSS116E will not boot after firmware upgrade from 1.0.0.2 to 1.0.0.5 after following upgrade instructions in the release notes. Upgrade from 1.0.0.0 to 1.0.0.2 and bootloader 1.0.0.5 was successful. All the LEDs stayed on after loading firmware 1.0.0.5. Reset button and power cycle has no effect. Is there a recovery method? Plus Click Switches (GSS116E)
This is the second unit I upgraded. The first upgrade was successful to 1.6.1.7.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: GSS116E will not boot after upgrade from firmware version 1.0.0.2 to 1.0.0.5.
Welcome to the community!
After performing a firmware update of the GSS116E to v1.0.0.5, is the switch still showing up in the ProSAFE Plus Utility tool? Also, are you able to ping its IP address?
If none works, you may request for an RMA (please see KB article here on how to do so).
Regards,
JeraldM
NETGEAR Community Team