- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Cant connect to ReadyNas Pro SMB1 Protocol ??
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
My readyNas Pro has being going great for quite a few years. I have three computers that connect to it, a laptop and two desktops.
Last week after the latest windows 10 updates, both desktops couldnt see or connect to the ReadyNas. Totally gone.
Laptop has no problems. I use ViceVersa Pro to back up my files to the ReadyNAS and it popped up with an error, that says "Target Folder not found, cant connect to the file share as its not secure. This share requires the obsolete SMB1 protocol, which is unsafe and could expose your system to attack."
Can anybody help with this. It did it straight after the windows update, but the laptop does not have any problems seeing it or connecting, but desktops do.
Thanks for any help.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can enable the SMBv1 client on the desktop systems by opening CMD (right-click and "run as administrator").
Then enter
sc.exe config lanmanworkstation depend= bowser/mrxsmb10/mrxsmb20/nsi
sc.exe config mrxsmb20 start= auto
Longer term, you probably should look into installing the NFS client on your PCs - that will give you an alternative to SMB1.
Another option is to upgrade your Pro to run OS-6. That will require a factory reset, so you would need to restore your data from backup. OS-6 support SMBv3.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can enable the SMBv1 client on the desktop systems by opening CMD (right-click and "run as administrator").
Then enter
sc.exe config lanmanworkstation depend= bowser/mrxsmb10/mrxsmb20/nsi
sc.exe config mrxsmb20 start= auto
Longer term, you probably should look into installing the NFS client on your PCs - that will give you an alternative to SMB1.
Another option is to upgrade your Pro to run OS-6. That will require a factory reset, so you would need to restore your data from backup. OS-6 support SMBv3.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Cant connect to ReadyNas Pro SMB1 Protocol ??
Thanks for your reply. Is my Pro capable of running OS6. ??? I dont mind doing a reset, and starting again.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Cant connect to ReadyNas Pro SMB1 Protocol ??
OK updated to OS6 and everything seems to be running ok.
Thanks for your help