- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
I have a readynas10400 that doesnt want to boot anymore
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
My RN10400 doesnt want to boot, it boots with the USB, goes out but doesnt buut without the usb
I was wondering if i take all HD and put them into a new RN314, will i recover my files?
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Cenoke,
Welcome to the Community!
Yes, if there are no issues on the volume on your RN104, the RN314 should boot normally when you insert the disks from the RN104 to the RN314 (disks should be on the same order) since both are OS6 devices. You may check this article for reference as well.
You can also install first a scratch disk (not from the array) to the RN314 and update its firmware, then remove the scratch disk, power down the system and insert the disks from the RN104 (disks should be on the same order).
Regards,
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Cenoke,
Welcome to the Community!
Yes, if there are no issues on the volume on your RN104, the RN314 should boot normally when you insert the disks from the RN104 to the RN314 (disks should be on the same order) since both are OS6 devices. You may check this article for reference as well.
You can also install first a scratch disk (not from the array) to the RN314 and update its firmware, then remove the scratch disk, power down the system and insert the disks from the RN104 (disks should be on the same order).
Regards,
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: I have a readynas10400 that doesnt want to boot anymore
Thank you so much for the reply!!
Greetz
C