Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Problem with Backup Exec System Recovery
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2011-07-18
11:33 AM
2011-07-18
11:33 AM
Problem with Backup Exec System Recovery
Hello,
I am Trying to backup a 2TB drive with Backup Exec System Recovery (BESR 2010) to a Share that was created on my ReadyNas NV+. The job starts and gets to about 5% then gives me these error messages:
error EBAB03F1:Error performing inpage operation
unable to set file size
error EBAB03F1: The specified network name is no longer available
unable to write to file
I can successfully backup to another location, just not to the readyNas.
Ive tried mapping using \\<IP ADDRESS>\sharename and to \\NAS_NAME\Share
Any help would be greatly appreciated!
Thanks
Flan
I am Trying to backup a 2TB drive with Backup Exec System Recovery (BESR 2010) to a Share that was created on my ReadyNas NV+. The job starts and gets to about 5% then gives me these error messages:
error EBAB03F1:Error performing inpage operation
unable to set file size
error EBAB03F1: The specified network name is no longer available
unable to write to file
I can successfully backup to another location, just not to the readyNas.
Ive tried mapping using \\<IP ADDRESS>\sharename and to \\NAS_NAME\Share
Any help would be greatly appreciated!
Thanks
Flan
Message 1 of 2
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2015-09-05
08:15 AM
2015-09-05
08:15 AM
Re: Problem with Backup Exec System Recovery
Hello darthflan,
Please make sure the share that is set as destination of the back up has no permission settings that will block any device or source that will access it. It also has to be in read/write permission not just read.
Regards,
Message 2 of 2