RN102 bricked

[brianjmc1]

Was working fine, lost power now all I get is a blinking power light. No Gui or SSH. I can telnet to it. I have tried factory restore, reload OS through USB, nothing seems to be working. Just wondering if its dead or not? Drives had NO data on them..

Thanks for any help!

[brianjmc1 · Accepted solution]

Previously formatted disk(s) detected (Dirty Disks)

[mdgm-ntgr]

What do you see in RAIDar?

Being able to telnet in would suggest that you've run into an error during the early stages of the boot process.

[brianjmc1]

It shows everything, Model, name, serial, status, firmware(6.4.0), IP address, and mac address..

Thank you for the help!

[mdgm-ntgr]

What's the status?

[brianjmc1]

"No disks detected" I pulled the disks, I have tried with them in too...

[mdgm-ntgr]

Do you get the same error with the disks installed?

If so, that would suggest either your disks are bad or there's a hardware issue with the chassis or external PSU.

[brianjmc1]

I will power down, power back up, then report back....

[brianjmc1 · Accepted solution]

Previously formatted disk(s) detected (Dirty Disks)

[brianjmc1]

MDGM got me going again. Once I formatted the drives, the GUI came back....

Thanks for all the help!!!

[mdgm-ntgr]

As you found after you clicked on the format button in RAIDar and confirm your choice the NAS wiped the disks and it has come up fine.

It's likely when the power failed the 4GB OS partition on the disks became out of sync. Anyway since you've wiped the disks there's no way to check now.

The OS is installed onto the disks.

You can now mark a post containing the solution to your problem as the solution.