- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: RN10400 GUI gone after firmware upgrade to 6.8.1
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
RN10400 GUI gone after firmware upgrade to 6.8.1
Upgrade from 6.7.1 to 6.8.0 failed with GUI via Internet connection.
So, I download 6.8.1 from the Netgear site and installed it via the GUI.
Again, the update failed.
Then, used the USB recovery tool to install 6.8.1.
After reboot, the GUI was no longer available. Instead, a screen showing files/directories under user admin was shown - see attached.
Keen to have the GUI admin back -- SSH was enabled.
Tim
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RN10400 GUI gone after firmware upgrade to 6.8.1
Hello ozngfans,
I understand that after the failed firmware upgrade via automatic and manual process the NAS admin page is no longer accessible. Can the raidar still detect the NAS on the network? If so please download the logs from the raidar and provide us a copy. You may use file sharing website like wikisend in sending us the logs and just PM me the download link.
Welcome to the community!
Regards,
Marty_M
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RN10400 GUI gone after firmware upgrade to 6.8.1
@Marty_M wrote:
just PM me the download link.
To be clear - "PM" means private message. Click on the "envelope" icon in the upper right of the forum page to send one.
Please don't post the download link on a public forum thread.