Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
RN2304 Slow not working on 6.10.8; stuck on volume syncing when reset to factory
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2022-10-28
11:04 PM
2022-10-28
11:04 PM
RN2304 Slow not working on 6.10.8; stuck on volume syncing when reset to factory
This is a replacement unit, it was shipped with 6.7.3
It was working fine until upgrade to 6.10.8
How do I revert it back to early firmware? which version is stable?
followed below to reset to factory,
Tried to follow below to create USB but this RN2304 is not listed,
https://kb.netgear.com/29952/How-do-I-use-the-USB-Recovery-Tool-on-my-ReadyNAS-OS-6-storage-system
Does the display port at the back work? I tried multiple mini display port cables/ adapters.
Thanks,
Alan
Message 1 of 3
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2022-10-28
11:08 PM
2022-10-28
11:08 PM
Re: RN2304 Slow not working on 6.10.8; stuck on volume syncing when reset to factory
Message 2 of 3
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2022-10-28
11:26 PM
2022-10-28
11:26 PM
Re: RN2304 Slow not working on 6.10.8; stuck on volume syncing when reset to factory
can't access to admin page
stuck on this page
Message 3 of 3