- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: RN31400 - lcd_panic_handle r+7d after 6.9.4
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
RN31400 - lcd_panic_handle r+7d after 6.9.4
Error recieved after updating through the web admin page. When booting the lcd displays Err: cannot extract properly then goes to the lcd panic message.
I have tried updating to 6.9.4 and 6.9.3 via usb recovery tool v2.0.T14 with no luck. I recieve the same messages as above. I was not able to find earlier versions of the usb recovery tool that others have had success with.
Has anyone seen this issue with 6.9.4? it seems to be pretty common issue with earlier updates. Any help is appreciated.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RN31400 - lcd_panic_handle r+7d after 6.9.4
Did you extract the firmware image from the zip file? Or did you install the zip?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RN31400 - lcd_panic_handle r+7d after 6.9.4
I extracted the images and put them in the x86 folder.
I've tried 3 usb drives: the current has been sitting at 'booting..' for 45 minutes now.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RN31400 - lcd_panic_handle r+7d after 6.9.4
Sorry, I meant during the upgrade attempts before the USB recovery.
If you have a scratch disk, you could try removing the existing disks (labeling by slot) and see if you can do a factory install onto the scratch disk.
If that succeeds, then a USB recovery won't solve your problem (since the flash is intact).
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RN31400 - lcd_panic_handle r+7d after 6.9.4
It asked if I wanted to update and reboot, I pressed the yes button, it went down and it never came back online.
I will try installing to another drive. It will boot into tech support mode and it also boots with no drives installed.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RN31400 - lcd_panic_handle r+7d after 6.9.4
You could also try an OS reinstall from the front panel - not sure if that will work or not.
If it's the OS partition on the disks, then a USB recovery won't help, and the procedure probably has some risk.