- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
RN316 Wasabi status
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
RN316 Wasabi status
Hi guys,
I have setup Wasabi backup to run from an RN316.
It shows that the Wasabi account is linked, and I can see on the Wasabi UI that data is being copied into the relevant bucker, but how do I check the status of the Wasabi backup from the NAS side?
Also, how often does the ReadyNAS backing up to Wasabi?
Many thanks in advance.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RN316 Wasabi status
On the NAS side unfortunately there's no UI or interface that shows the sync status to the Wasabi Bucket.
The NAS syncs data depending on the interval you have set (Hourly or Daily). You can actually change the sync interval by clicking on Settings and going to Options tab.
HTH
Regards
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RN316 Wasabi status
Thank you.
Is the interval that you refer to the "Download Sync Interval" setting under options?
Is there a Wasabi Sync Status in the works for a future ReadyNAS firmware release?
Thanks,
T
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RN316 Wasabi status
Welcome back!
Yes, it should be under Options/Settings.
I'm pretty sure it can be considered, you may want to post this as an Idea under the Ideas exchange board.
HTH
Regards