Ready NAS 102: Not booting

[vividpath]

Hello community,

My ReadyNAS 102 is all of sudden not booting.

Following is what I can note:

1) On power on, the power led, ACT, disk1, disk2 leds are lighting up for few secs.

2) After few secs:

    -> disk1 led: off

    -> disk2 led: off

    -> power led; blinking at the rate of 1 time per sec;

    -> ACT led: is also blinking

    -> A tik tik sound can be continuously heard (2 times per sec)

If I take out disk1,

-> power led is blinkingin a pattern: twice per sec, then no blink in the next sec and then again, twice per sec

-> disk1 led is off

-> disk2 led is on

-> no tik tik sound

-> cant connect to the readynas using readycloud.

Same is the case if i take out disk2, except disk1 led is on this time.

Raidar is not able to find any netgear device on the network.

Can someone suggest me how should i go about this issue?

Thanks a lot.

Best Regards,

Pradeep

[vividpath]

As I was writing this post, I let the readyNAS after power on, where the power led was continuously blinking.

In between I noticed that the box has been doing something.

1) shortly the disk1 led and disk2 led switched on, and then again off.

2) Then all the leds went off.

3) Then again power led switched on by itself and started to blink (1 time per sec)

I noticed that this process has repeated a few times.

Then again right now the power led is blinking one time per sec, and the disk1 and disk2 are off. The pattern above is not again happening.

The RAIDar is able to see the ReadyNAS 102 now, but the status on RAIDar is showing "No disks detected"

I am curious what the box is doing!!

Is it working at all? Is my data safe?

[StephenB]

I suggest that you contact netgear support.