× NETGEAR will be terminating ReadyCLOUD service by July 1st, 2023. For more details click here.
Orbi WiFi 7 RBE973
Reply

Re: ReadyNAS 104 - one NIC offline in a team (dead NIC?) ?

MikeB666
Tutor

ReadyNAS 104 - one NIC offline in a team (dead NIC?) ?

I have two ReadyNAS 104 devices,  they are both identically configured.

On one system both NICs are active (lots of lights on the switch) as they are configured for Adaptive Teaming, however the second identically configured ReadyNAS only seems to be working on one NIC.

Itis not the switch or cable (done the usual swap over) and there are no lights on the NIC port on the back of the ReadyNAS (as there are on the other port) 

Now I am sure this used to be both ports active like the other ReadyNAS, so I broke the Team and it looks like one NIC is grey and the other is Green, so is this a hardware failure ?

If so, as the ReadyNAS 104 is cheap is is possible to remove the disks after shutting it down and replace them in the same order in a new chassis and have it correctly use the RAID set so getting me back to a working system?

Is there any other log or remote access that I can do to confirm the failure?  And if so is the above of just moving the disks to a new chassis viable (with no loss of data - as I do not waat to have to re copy 7TB of data to it)

 

Regards

 

Mike

Message 1 of 6

Accepted Solutions
mdgm-ntgr
NETGEAR Employee Retired

Re: ReadyNAS 104 - one NIC offline in a team (dead NIC?) ?

You would open an online support case. For an RMA if approved there are a few options.

 

You can send the faulty unit in after being given the RMA number and instructions on where and how to send the defective unit and wait for a replacement.

 

Or if you want a replacement quicker pay for advanced shipping of a replacement unit and then you send the defective unit back. You would need to provide credit card details so that if the faulty unit is not returned you will be billed for the replacement unit.

 

Support can explain these options and the costs involved.

View solution in original post

Message 6 of 6

All Replies
StephenB
Guru

Re: ReadyNAS 104 - one NIC offline in a team (dead NIC?) ?


@MikeB666 wrote:

I have two ReadyNAS 104 devices,  they are both identically configured.

On one system both NICs are active (lots of lights on the switch) as they are configured for Adaptive Teaming, however the second identically configured ReadyNAS only seems to be working on one NIC.

 

It is not the switch or cable (done the usual swap over) and there are no lights on the NIC port on the back of the ReadyNAS (as there are on the other port) 

Now I am sure this used to be both ports active like the other ReadyNAS, so I broke the Team and it looks like one NIC is grey and the other is Green, so is this a hardware failure ?


Sounds like it to me. I'd contact support and ask about an RMA.


If so, as the ReadyNAS 104 is cheap is is possible to remove the disks after shutting it down and replace them in the same order in a new chassis and have it correctly use the RAID set so getting me back to a working system? ... just moving the disks to a new chassis viable (with no loss of data - as I do not want to have to re copy 7TB of data to it)

Yes.  Best practice is to install the OS6 firmware you are running on the current NAS on the replacement (using a scratch disk).  Then power down, insert the new drives, and you are good to go.

 

FWIW, you can similarly migrate to an RN300 or RN500.  The general rule with OS6 is that you can migrate up (or level) but not down. 

Message 2 of 6
MikeB666
Tutor

Re: ReadyNAS 104 - one NIC offline in a team (dead NIC?) ?

Ok - so assuming it is a dead NIC, just to clarify.

If I purchase a new chassis, use a scratch disk in a caddy to do the firmware update then if I install the original 4 4TB disks in the same slots in the new NAS as they were in the one with the dead NIC, they will be recognised as a RAID set and all the data will be intact etc. ?  So I will not lose any data nor will I have to reformat etc the drives when swapped to the new chassis?

 

Thanks for your input.

 

Regards

Mike

 

 

Message 3 of 6
vandermerwe
Master

Re: ReadyNAS 104 - one NIC offline in a team (dead NIC?) ?

Not sure if you meant this or not, but to be clear the scratch disk should not be "in a caddy".  You need to put a spare disk into the new nas, power up, access the GUI and then update the firmware.  Once this is done, power down, remove the spare disk, insert your existing array, preferably in the same slots as they were in, then boot up.

You should find everything is ok, data included.

 

There are risks associated with not having a backup, particularly when you need to perform manoeuvres like this.  If you wanted to be extra careful you could clone each disk in the array onto new disks so that you had a copy.

 

Did you actually plug in a live ethernet cable to the "dead" NIC while the other was unplugged.  I suspect Netgear would want you to do this to confirm there is no NIC activity light and raidar does not see the nas.

 

Why do you want to buy a new chassis?  If there is a hardware failure you will get a RMA chassis from Netgear for nothing.

Message 4 of 6
MikeB666
Tutor

Re: ReadyNAS 104 - one NIC offline in a team (dead NIC?) ?

Hi,

 

By Caddy I meant that the scratch disk will be in one of the plastic frames that hold the disks in the 104 NAS.

So understood that I just use a scratch disk in one slot of he NAS to do the OS/firmware update,  then put the disk into the slots from the old NAS into the new in the same slots.

Funnily enough this NAS is actually backing up another 104 NAS (belt and braces, as the first NAS is backing up a file server).

 

I have swapped the cables in all ways between the NIC ports and switch and the top NIC is dead, no light on the back at all for that port on the NAS or the switch.

So reasonably confident it is dead.

 

As regards getting an RMA - do you mean that Netgear will send me a replacement unit when I return mine to avoid being without for too long?

Any idea which link to start at to find out the process to do this?

 

Thank you for your time on this.

 

Mike

Message 5 of 6
mdgm-ntgr
NETGEAR Employee Retired

Re: ReadyNAS 104 - one NIC offline in a team (dead NIC?) ?

You would open an online support case. For an RMA if approved there are a few options.

 

You can send the faulty unit in after being given the RMA number and instructions on where and how to send the defective unit and wait for a replacement.

 

Or if you want a replacement quicker pay for advanced shipping of a replacement unit and then you send the defective unit back. You would need to provide credit card details so that if the faulty unit is not returned you will be billed for the replacement unit.

 

Support can explain these options and the costs involved.

Message 6 of 6
Top Contributors
Discussion stats
  • 5 replies
  • 3686 views
  • 1 kudo
  • 4 in conversation
Announcements