- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
ReadyNas Ultra 6 Snapshots on v6.9.4
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have 3 x 3TB HDD (with 1 running as a redundant drive, so 6TB of space available).
Currently the GUI is telling me that I have 2.5TB used in Snapshots. But I haven’t taken any Snapshots.
I have just gone through a disables all Snapshots, and done a Disk Balance to no availe. In fact, once the Disk balance finished, I had even more space used in Snapshots.
Please help me delete these Snapshots as they are taking up a lot of space.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
my issue was resolved by a great person in this group over email.
thanks so much i appreciate it.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: ReadyNas Ultra 6 Snapshots on v6.9.4
Hi @bakthomas
You may want to check this thread, this might be helpful. Also, try to check if you have snapshots stored so you can delete them. Here is an article for that.
Also, disabling quota on volume level might be of help.
Hope this helps!
Regards
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: ReadyNas Ultra 6 Snapshots on v6.9.4
Thanks Marc, I had previoucly found both of the articles, and they haven't helped.
I think the problem is that my Snapshots weren't ugraded when I upgraded my version.
This is my current volume size:
This is my share listing
This is what the snapshots looks like
This is what it looks like when i select a specific folder
So, I have a whole bunch of data used in Snapshots, but nowhere to see it.
I have tried a balence, a scrub, and I have even tried the following through SSH:
touch /. force_snapshots_upgrade
systemctl restart readynasd
But I never see the GUI say that and update is happening.
I am at a complete loss as to what to do.
This is my current version, I have been uprading whenever an update become available (it was originally on 4.x)
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
my issue was resolved by a great person in this group over email.
thanks so much i appreciate it.