- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Readynas Replicate not working - unable to get local p2p address
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Readynas Replicate not working - unable to get local p2p address
Hello,
I am having a problem using Readynas Replicate from a Pro-2 running 6.6.0 to a RN-102 running 6.6.0
I'm getting the error:
unable to get local p2p address
unable to get p2p local ip address
Both NAS are on the same network, and I have another RN-102 that the Pro-2 can backup to using Replicate; so it's quite strange.
I've read quite a bit of posts that the p2p config is probably corrupted.
Where can I find this config file so that I can inspect it?
I will just compare the config from the working RN-102 to the non-working RN-102.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Readynas Replicate not working - unable to get local p2p address
I have been unable to get either ReadyNas Replicate or ReadyNas Remote to work for 2 weeks. Similar message to previous post for Replicate.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Readynas Replicate not working - unable to get local p2p address
The shares are accessible and writeable. I'm pretty sure I got some relief from this thread - https://community.netgear.com/t5/Current-NETGEAR-and-Partners/Replicate-fails-with-error-501/td-p/11...
It's the only thread that actually mentioned the config that needs to be fixed. Every other thread they said config was corrupted, and support remoted in and fixed it, but failed to mention what actually needed to be fixed..