NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
SMB over RN528X not working
Setup: - Core i7 PC, Win10 Home x64, with Intel X550-T2 dual 10GbE NIC card, and EVO 970 Plus SSD hard drive - XS716E 10GbE switch - RN528X with dual 10GbE ports - RN212 with dual 1GbE ports - Q...
jimk1963 wrote:
The promise of SMB multichannel is much different.
AFAIK SMB multichannel isn't enabled on the NAS.
StephenB wrote:
jimk1963 wrote:The promise of SMB multichannel is much different.
AFAIK SMB multichannel isn't enabled on the NAS.
Thanks Stephen, thought I read that it was supported somewhere but am looking again and all I see is SMB3 support, but SMB Multichannel is "experimental" per Samba and not enabled on the NAS. This is same story as QNAP NAS. With QNAP, there are several good videos showing how to SSH into the NAS and change the Multichannel to "True". Do you know if that's possible on ReadyNAS? I've used Putty to SSH into the RN528X but don't know the syntax once I'm in there and don't want to mess anything up.
I did run Powershell's "get-smbserverconfiguration" command on my PC and "EnableMultiChannel" is True in the list, as are EnableSMB1Protocol and EnableSMB2Protocol. There's no entry for SMB3 in the list. I don't know run the equivalent command with Putty on the NAS.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
