- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Update still fails
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Still frustrated. I was not able to udate from 6.2.5 to 6.4.1. I had posted before on this. Uploads to the drive (direct or over the internet), reboots but never updates. Have tried the "complete_upgrade_flash..." app, but it uploads but never runs.
I waited for 6.4.2, but the results are the same. On al older suggestion, I did a factory reset and then tried an upgrade, but again same results - never installs.
Checksum issue ? The workaround patch never installs.
I have 4 ReadyNas drives, 2 2 bay and 2 4 bay. All updated w/o problem except for the one 2 bay drive.
Anyone have any ideas, or am I forever stuck with 6.2.5 ?
Paul
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
After a PM and some assistence from "mdgm" of Netgear my upgrade went in and all is good.
Great factory support from my perspective.
paul
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
After a PM and some assistence from "mdgm" of Netgear my upgrade went in and all is good.
Great factory support from my perspective.
paul