This topic has been marked solved and closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
The Wake-on-LAN feature appears to be completely broken on my ReadyNAS 102. If the WOL feature is enabled in the Power settings, the system will not stay powered off if the network cable is plugged in. I know this sounds impossible, but I tested this extensively.
If I power off the NAS from the front panel, it goes through the power off. About 5 seconds later the system powers back on. If I disconnect the LAN cable from my switch, the NAS stays off. As soon as I plug in the cable, the system powers on. This will occur with NO OTHER DEVICES plugged into the 8 port switch.
I believe that this started when I upgraded to the lastest firmware version. I was going to backdate the firmware but the NAS doesn't allow me to do that.
Two Questions:
1. How can I backdate the Firmware to confirm that it is the new firmware. Hopefully without wiping out my Disks.
2. Is there a way to fix this with the latest firmware.
You can manually downgrade to 6.4.0 (but not before). However if that is the only issue you are having, then I'd suggest going with 6.4.2 beta instead.
You can manually downgrade to 6.4.0 (but not before). However if that is the only issue you are having, then I'd suggest going with 6.4.2 beta instead.
