× NETGEAR will be terminating ReadyCLOUD service by July 1st, 2023. For more details click here.
Orbi WiFi 7 RBE973
Reply

boot problem RN102 after update

ben24
Aspirant

boot problem RN102 after update

Hi 

 

I was working on my NAS, and I gues I triggered an update.
After the update I wasn't able to connect to my NAS.

What I did now is that I booted without disks, configured new NAS and then insterded my 2 disks again.

I activated the diagnostic mode under settings -> support -> diagnostic.

Can you please provide support.

Thanks.
Ben

Message 1 of 5
Lyne-Laliberté
Aspirant

ac1200 wi-fi adapter usb 2.o a6150-100pas impossible to connect to router cambium networks

 
Message 2 of 5
schumaku
Guru

Re: boot problem RN102 after update

A RedyNAS can't be configured that way. Strictly stick the documented installation procedure. The NAS configuration is held on the installed internal mass storage, no other config storage option.

 

... ac1200 wi-fi adapter usb 2.o a6150-100pas impossible to connect to router cambium networks ... 

 

Similar, ReadyNAS does not support wireless clients like this named ac1200 wi-fi adapter usb 2.o a6150.

Message 3 of 5
ben24
Aspirant

Re: boot problem RN102 after update

This is what I get. I cannot afford to lose the data by deleting partitions on disks. Is there a way to recover data. I tried updating to latest firmware but it isnt booting drom disks. Only if i remove them i can boot.
Message 4 of 5
ben24
Aspirant

Re: boot problem RN102 after update

Oops. Image didnt upload. Its says “no volume exists” after plugging in my two RAID 1 disks
Message 5 of 5
Top Contributors
Discussion stats
  • 4 replies
  • 697 views
  • 0 kudos
  • 3 in conversation
Announcements