- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
ReadyNAS Ultra 2 after power outage, no longer starting cifs/ samba
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ReadyNAS Ultra 2 after power outage, no longer starting cifs/ samba
Last week tuesday, I have had an power outage.
And so the ReadyNas Ultra 2 was restarted. It was running fine afterwards.
However in the evening, I tried to watch a movie, which resides on the NAS, and I was unable.
So then the investigation started, and I was unable to access my shares, and checking from the gui, cifs/ samba is not started.
and if I enable it, and press apply, it says, OK, will do, but nothing happens.
If I go to logs, I have no entries.
What I tried as fix, was to re-install the base OS, the non disruptive option, and this did NOT solve the problem.
What I can do, but only if you say it makes sense, is reset to factory default, and wipe the data, as I have a backup. But I see that as a last resort.
Do you guys/ ladies, maybe have any ideas ?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: ReadyNAS Ultra 2 after power outage, no longer starting cifs/ samba
some more info:
Model: | ReadyNAS Ultra 2 [X-RAID2] |
Serieel: | *** |
Firmware: | RAIDiator 4.2.27 |
Geheugen: | 1024 MB [DDR3] |
IPv4-adres: 1: | Niet verbonden |
IPv4-adres: 2: | 192.168.178.21 |
Volume C: | Online, X-RAID2, 2 schijven, 89% van 1846 GB gebruikt |
language is dutch, but I think it is understandable
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: ReadyNAS Ultra 2 after power outage, no longer starting cifs/ samba
Are you running CrashPlan?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: ReadyNAS Ultra 2 after power outage, no longer starting cifs/ samba
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: ReadyNAS Ultra 2 after power outage, no longer starting cifs/ samba
after digging further, I can understand the crashplan question.
most likely not the correct java version 7 or 8 was there, and was crashplan each time trying to update, this failed, but this might also have caused the filesystem to become full
to bad I am now in the process of factory reset, possibly I would have been able to fix it by means of ssh access, to create space
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: ReadyNAS Ultra 2 after power outage, no longer starting cifs/ samba
hi all,
after some jre version 8 troubles, and sligth change in how to connect.
i have now crashplan running again, on the netgear!!!
now synchronising block info, and afterwards, I will start the restore, and then the waiting will start, to have all the 1,6Tb restored.....