Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
SRX5308 - WAN2 not working
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2014-01-15
10:46 AM
2014-01-15
10:46 AM
SRX5308 - WAN2 not working
I have confirmed with the Data Centre that there is a green light on at both ends of the WAN Broadband connection, on WAN Port 2 on the SRX5308 AND at their Network Supply Port.
WAN 1 is working perfectly
WAN 2 is not showing anything
I have input all the correct settings on WAN 2 in the TAB/Page 'WAN 2 IPv4 ISP Settings'
But it never displays it's settings on the TAB/Page 'WAN Setup'
Is there something additional I have to do to get WAN 2 to activate?
Thank you,
WAN 1 is working perfectly
WAN 2 is not showing anything
I have input all the correct settings on WAN 2 in the TAB/Page 'WAN 2 IPv4 ISP Settings'
But it never displays it's settings on the TAB/Page 'WAN Setup'
Is there something additional I have to do to get WAN 2 to activate?
Thank you,
Message 1 of 5
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2014-01-15
04:08 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2014-01-16
03:46 AM
2014-01-16
03:46 AM
Re: SRX5308 - WAN2 not working
Thank you ADIT
I set up the Auto-rollover option as per attached screenshot.
Would that not work as well ?
My goal is to test that WAN2 works, before switching broadband cables in WAN1, eventually only needing to use WAN1 again.
I set up the Auto-rollover option as per attached screenshot.
Would that not work as well ?
My goal is to test that WAN2 works, before switching broadband cables in WAN1, eventually only needing to use WAN1 again.
Message 3 of 5
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2014-01-16
04:40 AM
2014-01-16
04:40 AM
Re: SRX5308 - WAN2 not working
WAN2 will not go Active unless WAN1 fails in that mode.
The only way to have both up/Active is Load Balancing.
What do you mean by switching cables?
Message 4 of 5
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2014-01-31
01:30 PM
2014-01-31
01:30 PM
Re: SRX5308 - WAN2 not working
Got it working thank you with load balancing.
We have not reverted to the new 100Mb line in WAN1 and all is good.
Cheers 🙂
Message 5 of 5