Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: EX6100N AP mode - lan led blinks, no connection to the network
Retired_Member
Not applicable
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2014-12-07
02:07 PM
2014-12-07
02:07 PM
EX6100N AP mode - lan led blinks, no connection to the network
Hello,
I have two EX6100 which are cascaded via netgear Switch, a HP switch to an UTM.
However, *both* EX6100 became blinking on the lan port and there was no access any more.
When connecting them directly to the HP switch, they work again so far.
I used different cables etc.
Please advise.
I have two EX6100 which are cascaded via netgear Switch, a HP switch to an UTM.
However, *both* EX6100 became blinking on the lan port and there was no access any more.
When connecting them directly to the HP switch, they work again so far.
I used different cables etc.
Please advise.
Message 1 of 2
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2014-12-10
11:38 AM
2014-12-10
11:38 AM
Re: EX6100N AP mode - lan led blinks, no connection to the network
cabledog,
netgear Switch might be no good. Can you see if you can test it on some other devices?
netgear Switch might be no good. Can you see if you can test it on some other devices?
Message 2 of 2
Announcements
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more