Setting up a WN3000RP V1H2 Wifi range extender to be utilized connected to an ethernet cable

[KenCollinsSD-CA]

I have a few years old WiFi range extender model WN3000RP V1H2.  I am needing now to extend the range farther than the source wifi reliably reaches.  I happen to also  have a desktop PC (without wife broadcast capability) connected with RJ45 ethernet cable to the home's main modem router, model C3000.  If I cable connect the range extender to the port hub near the PC, is there a way to configure the range extender to boradcast wifi for other wireless devices nearby?  (I've searched and read a few posts here, but they were not for this exact model number and the comments and instructions were not specific enough for me...)  Thanks,

[Fosforus]

I had similar issue -  have copies of the pdfs for WN3000RP V1H2 (stuff as at October 2014 !!) - I've tried adding a copy this reply - give me your e-mail and I'll send the others.

[Fosforus]

The remaining 2 pdfs attached.

[Fosforus]

Didn't manage to fully succeed on last attempt - attached last of 3 pdfs that I have.

[KenCollinsSD-CA]

Fosforus,

Thanks for the reply with the orignal product pdfs.  It looks like the product still won't do what I was hoping: to extend the reach of my wifi by having an ethernet cable allow me to locate the extender farther away from the router than its wifi signal can go.  I think I will have to buy some of those units that send the wifi through the house AC wiring to remote  transmitters.

Thanks,

Ken