WG302v2 original firmware restore

[Munch]

Ahhh. Thanks. I will get a chance in a hour to do it and get back if it still dosen't work

thanks

[Munch]

Driusha wrote:
RedBoot> fis init -f RedBoot> ip_address -l 172.16.3.228 -h 172.16.3.89

Sorry to be a pain and not have my computing brain on today, but if i was to configure the AP to the address's listed above what would i need to set the IP address of the computer that I am downloading the firmware from!

Thanks in Advance

[Driusha]

Your PC IP should be 172.16.3.89

[Munch]

Ok so I have set my Computer IP address and set the IP address's on my AP, what do I need to do know on the TFTP server to put the new firmware onto the AP? Sorry for all of the questions!

Thanks in Advance

Munch

[dianc]

Munch wrote:
Ok so I have set my Computer IP address and set the IP address's on my AP, what do I need to do know on the TFTP server to put the new firmware onto the AP? Sorry for all of the questions! Thanks in Advance Munch

Hi,Munch:

You need learn some knowledge,before do the flash thing.

See bellow
http://oldwiki.openwrt.org/OpenWrtDocs(2f)Hardware(2f)Netgear(2f)WG302.html

[jonp]

I rather stupidly flashed a WG302v1 firmware on to what rusn out to a V2 unit.

I've tried the same method above to fix the unit but after running

"exec -b 0x01900000 -l 0x00100000 -c "console=ttyS0,9600 root=/dev/mtdblock2 rw rootfstype=jffs2"

The test light stays lit and I can't access the unit and nothing show on terminal.

I used the same firmware as mentioned in this thread (5.2.3)

Any ideas on what I can do to get this working?

If I hold the reset button during power on it requests config.bin and xg3020.rmt.