Reply
Highlighted
Aspirant

WN2000RPTv2 - Unable to connect extender to the router or ADSL modem

My repeater WN2000RPTv2 ( firmware 1.1.0.12 ) presented signal loss, gave a reset and it lists the neighboring networks, allows you to select, but not complete the connection, already I tried to connect with my WNR2000v4 and direct with my ADSL modem without success.

Message 1 of 10
Highlighted
Virtuoso

Re: WN2000RPTv2 - Unable to connect extender to the router or ADSL modem

Does your extender detects the wireless network of the WNR2000v4? Do you get an error message when unable to connect?
Message 2 of 10
Highlighted
Aspirant

Re: WN2000RPTv2 - Unable to connect extender to the router or ADSL modem

Yes I've put them side by side and extend recognizes the wireless network with 100% signal, but to finish the process in the wizard or manually, it reports that the router is out of reach.
Message 3 of 10
Highlighted
Virtuoso

Re: WN2000RPTv2 - Unable to connect extender to the router or ADSL modem

Please check the MAC filtering or Access control if enabled in the router. Disable it and connect again the extender.
Message 4 of 10
Highlighted
NETGEAR Employee Retired

Re: WN2000RPTv2 - Unable to connect extender to the router or ADSL modem

Is your ADSL modem set to Bridged Mode? What is the manufacturer / model number of the modem?
____________________________
Working on behalf of Netgear
My name is Andy
Message 5 of 10
Highlighted
Aspirant

Re: WN2000RPTv2 - Unable to connect extender to the router or ADSL modem

Already tested my ADSL modem (Cisco DPC3925 DOCSIS 3.0) in brigded mode and router mode in both tests the repeater reports that the router is out of reach, looks like happens with I use my WNR2000v4.
Message 6 of 10
Highlighted
Aspirant

Re: WN2000RPTv2 - Unable to connect extender to the router or ADSL modem

And no MAC filtering or Access control enable in ADSL modem or WNR2000v4. Tks.
Message 7 of 10
Highlighted
Virtuoso

Re: WN2000RPTv2 - Unable to connect extender to the router or ADSL modem

Does your computer still sees the network of the WNR2000v4? Can they connect fine?
Message 8 of 10
Highlighted
NETGEAR Employee Retired

Re: WN2000RPTv2 - Unable to connect extender to the router or ADSL modem

Your Cisco DPC3925 DOCSIS 3.0 is a cable modem, so I assume you don’t have an ADSL service. Still that modem is a Residential Gateway and operates as a router, are you sure that it is set to modem only, how did you do this?

Can you please post the exact text of the message that you see, or maybe a screen grab?
____________________________
Working on behalf of Netgear
My name is Andy
Message 9 of 10
Highlighted
Aspirant

Re: WN2000RPTv2 - Unable to connect extender to the router or ADSL modem

Hi,

Sorry for the delay I've been very busy these last months.

Well my Cisco has been configured as a bridge and turned off wi-fi,
connected him my WNR2000v4 and tried to set up WN2000RPTv2 but to no
avail after all the procedure done manually or through the wizard,
it states that "The router is out of reach". Maybe a new version of
firmware for the WN2000RPTv2 ( actual 1.1.0.12 ) or even a way for
me to downgrade for a new test?

Tks,
Message 10 of 10
Top Contributors
Discussion stats
  • 9 replies
  • 5622 views
  • 0 kudos
  • 3 in conversation
Announcements