I have an MR60 with two MS60 sattelites (purchased from Costco). After initial setup I was able to update the firmware through the Nighthawk app to v1.0.6.102 (the same version firmware is running on both the router and the sattelites). Everything has been running great.
On 27-Jun I received the email alerting me to an urgent firmware update. When I visit the product page at https://www.netgear.com/support/product/mr60.aspx and click "Firmware and Software Downloads", I see that there's a "MR60 (Mesh Router) Firmware Version 1.0.6.110" and a "MR60 (Mesh Router) Firmware Version 1.0.6.112 - Hot Fix" available.
When I open the Nighthawk app on my [Android] phone (it is version 2.10.5.1633), from the app's main page, when I ...
tap the image of the router with the swirly animation (it shows Network Map),
tap the image of the MR60 router,
tap "Details",
tap the 3-dot menu at the upper-right,
tap "Check For Updates"
...the app says "Checking for New Firmware" at the top and "Wait about 5 minutes..." at the bottom. After a pause (less than a minute) it says "Your Firmware is up to date" and gives me the big "OK" button.
Also from the main page, when I ...
tap the "cloud" (?) button at the upper left,
tap SETTINGS,
tap Router Settings,
tap the blue "CHECK FOR UPDATES" button,
...I get the same screen as above (the app says "Checking for New Firmware" at the top and "Wait about 5 minutes..." at the bottom). After a pause (less than a minute) it says "Your Firmware is up to date" and gives me the big "OK" button.
My MR60 is connected to my FiOS gateway router, if that makes a difference. I can see the MR60's IP address on the FiOS router's admin page, but if I try to connect to it directly I am timed out.
