NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
ReadyNAS "Admin Page" is offline
Upgraded to firmware 6.7.5 through the web interface and now the unit is not responing via the browser at all. SMB share is still working Tried Rebooting Tried Reset via reset pin on back and selecting OS Reinstall - same issue Raidar Diagnostic will not connect, but raidar says unit is healthy ! I cannot download the logs because login is not working, I know the password before someone suggests password recovery. Looking at USB recovery but cannot get the tool to recognise any firmware to make a usb for me. Format USB to Fat32 and put these in root Reboot machine and hold backup for 30 seconds. Machine says booting from usb, then after a few minutes, resets and does FW Upgrade. But the firmware is still 6.7.5 ?? How to do it? What am I doing wrong? I know the issue is network adapter related because "\\192.168.1.101\folder" is working fine, but "\\192.168.1.147\folder" comes up with network error do i want to diagnose? If I factory reset it with different disks in it, can I the set it to x-raid and put back the original disks without losing data? Will factory reset put the original firmware back in or will it use 6.7.5 ? I really want to get this working again :( Many thanks for any helpOS 6.6.1 on Ultra 6 - Temperature readings incorrect
This looks to be a bug in 6.6.1 using my Ultra 6 (legacy) NAS. And I can't make sense of what is wrong: We have a ducted air conditioned house at around 25 degrees ambient My "CPU temperature" seems to have a "floor" of at or around 35 degrees and doesn't deviate too much from it, no matter the load... My "System temperature" fluctuates more erratically and is a higher temperature I decided to run a stress test (using "stress" via SSH). I ran a 5 minute test, with results below: The graph says the light blue CPU temp fluctuates from 47 to 57 degrees - which does not align to the text temp under the graph. Same is true for dark-blue system, which temperate increase lags the light-blue CPU, but the text under the graph says it's the lower temperature. So I guess I am trying to say: The thermometer temp guages at the top should be switched around so the system temp is ~35 degrees and is relatively stable (given the Hard disks are between 33-37 degrees, and air conditioning at 25 degrees) and the CPU temperature should be at 47 degrees and fluctuate more widely with load... The text under the graph should also be swapped. Funny thing is, sensors via SSH shows: coretemp-isa-0000 Adapter: ISA adapter CPU: +35.0°C (crit = +100.0°C) it8721-isa-0a10 Adapter: ISA adapter V5_0: +4.96 V (min = +4.76 V, max = +5.14 V) V3_3: +3.28 V (min = +3.13 V, max = +3.46 V) V1_8: +1.81 V (min = +1.50 V, max = +2.10 V) V-12: -12.10 V (min = -13.24 V, max = -10.73 V) 3VSB: +3.24 V (min = +3.14 V, max = +3.46 V) Vbat: +3.34 V System: 1205 RPM (min = 399 RPM) System: +52.0°C (low = +1.0°C, high = +80.0°C) sensor = thermal diode So OS6 web dashboard is showing what SENSORS is showing - but SENSORS has to be wrong... doesn't it?
