- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
CM1200 Modem Upstream Light Flashing
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
CM1200 Modem Upstream Light Flashing
The upstream light on my CM1200 is continously blinkinking. I do have internet service, but the modem admin console says that the upstream bonded channels only have partial service and show only 1 channel locked.
There are lots of errors in the log. The below is repeated over and over.
Is this a modem problem or is this Comcast?
Thanks for any help
Eric
Thu May 27 08:10:05 2021 | Critical (3) | No Ranging Response received - T3 time-out;CM-MAC=28:80:88:af:7e:40;CMTS-MAC=00:01:5c:b2:9c:67;CM-QOS=1.1;CM-VER=3.1; |
Thu May 27 08:09:14 2021 | Critical (3) | 16 consecutive T3 timeouts while trying to range on upstream channel 3;CM-MAC=28:80:88:af:7e:40;CMTS-MAC=00:01:5c:b2:9c:67;CM-QOS=1.1;CM-VER=3.1; |
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: CM1200 Modem Upstream Light Flashing
do you have a screen snip of the cable connections page? (all of it)
Also, if you have any splitters, amplifiers, or signal attenuators in the coax line, remove them.
check the line for kinks, damage, old/bad/corroded/cheap cables and connectors. replace them if you do.
preferably, move the modem to right where the coax enters the home.
User | Count |
---|---|
9 | |
4 | |
3 | |
2 | |
2 |
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more