- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
br500 vpn connection error "an error occurred while processing the request Try again"
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
br500 vpn connection error "an error occurred while processing the request Try again"
When I try to connect one of my BR500's to the VPN group, I've been getting an error "An error occurred while processing the request Try again" I've been trying over 1 week same results. The BR500 is on-line, and I've tried rebooting the unit remotely. I've never had this happen before. Any ideas appreciated. Thanks Ray
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: br500 vpn connection error "an error occurred while processing the request Try again&quo
Noticed that the memory allocation of this BR500 is 100%. The data transfer is also very high even though it is not connected to a network. The CPU usage is lower. A remote reboot did not help.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: br500 vpn connection error "an error occurred while processing the request Try again&quo
Kindly try to perform a factory reset on your BR500 then check if the same problem will occur.
Also, if ever you are not yet aware, please read the article below:
Security Advisory for Multiple Security Vulnerabilities on BR200 and BR500, PSV-2021-0286
Regards,
DaneA
NETGEAR Community Team