AC2600 not connecting

---

User007M wrote:
Recently moved to a new house with same ISP.

---

It may be the same ISP. but you have changed quote a few things on our network.

Did you set up  whatever this AC2600 is from scratch.

There may be some subtle changes in the local network configuration.

If the router is delivering as it should, there's a couple of easy options

• Go onto the router's browser graphical user interface (GUI) and take it through the Internet setup wizard
• Reset the router and set it up from scratch.

How do I perform a factory reset on my NETGEAR router? | Answer | NETGEAR Support

Find more in the manuals for your router.

Visit the support pages:

Support | NETGEAR

Feed in your model number and check the documentation for your hardware.

Look for the model number on the label on the device.

That page will also have any software, firmware and drivers for your device, if they exist.

You may have done that already. I can't tell from your message.

I mention it because Netgear gave up on supplying paper manuals and CD versions some years ago and people sometimes miss the downloads.

What model router do you have? AC2600 is a wifi speed. 

Has a power off for 1 minute then back ON with the ISP modem and router been performed since last update?
Be sure to restart your network in this sequence:
Turn off and unplug modem.
Turn off router and computers.
Plug in and turn on modem. Wait 2 minutes for it to connect.
Turn on the router and wait 2 minutes for it to connect.
Turn on computers and rest of network.

Has a factory reset and setup from scratch been performed since last FW update? A complete pull of the power adapters for a period of time after the factory reset then walk thru the setup wizard and setup from scratch with a wired PC and web browser. Recommend setting the default DHCP IP address pool range to the following after applying and a factory reset: 192.168.#.100 to 192.168.#.200.
https://kb.netgear.com/24089/How-do-I-specify-the-pool-of-IP-addresses-assigned-by-my-Nighthawk-router

Be sure your only connecting the router to the CM modems WAN port 1 and remove all other devices from the CM modem. These are not LAN ports.