NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
How to unbrick the Nighthawk R7000 using OS X and TFTP
Hi,
After spending a night on unbricking my R7000 and how I struggled to work with all the manuals out there but none of them actually worked. I thought I should share what actually worked for ...
HOLY COW IT WORKED!!!
nmrpflash worked!!! Switching to a Static IP address and turning my Wifi off did the trick!!
Also, recommend using -vvv to double check when it works. Took me two tries to nail the timing because the router has to finish restarting for the packet transfer to begin before the command times out.
I want to thank all for their help, support and advice. I was finally able to upload the new firmware. It was my fault that I had so much trouble doing so. Stupid rookie non tech savvy mistake. I copied the whole file to my desktop versus just the exe green file. Once I found the errors of my ways, the firmware loaded flawlessly and I'm up and running.
Again, thanks to all.
> [...] I copied the whole file to my desktop versus just the exe green
> file. [...]
I'll bite. Which "the whole file"? And what's a "the exe green
file"?