NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
New - R7000 Firmware Version 1.0.11.134 Released
Security Fixes: 02/16/2022
Fixes security vulnerabilities.
For more information about security vulnerabilities, visit https://www.netgear.com/about/security/
Download Link:
https://w...
Loaded v134 on my R7000 today. Factory reset and setup from scratch.
Noticed that the onboard speed test results are not to spec on a 1Gb down ISP service:
Possible speed test service site issue. Similar happening on a R8000 router.
Wired PC speed test results are to spec:
5Ghz iPhone 12 Pro Max speed test results:
Thats around to spec speeds for 5Ghz AC.
2.4Ghz iPhone 12 Pro Max speed test results:
Have Traffic Meter, Parental Controls and Armor trial enabled. Will let this run for the week and see how it goes.
Wired WAN to LAN speeds are still good here:
My R7000 has been solid since updating to v134 from v130 several days ago. To avoid the kind of trouble I've had after previous updates, I did a factory reset before and after installing v134 and then manually entered all my configuration including my 29 reserved IP addresses.
Be sure to save off a back up configuration to file for safe keeping. Saves time if a reset is needed.
https://kb.netgear.com/24231/How-do-I-back-up-the-router-configuration-settings-on-my-Nighthawk-router
I checked my R7000 today and I can access the Advanced Tab and pages fine: MS Edge
No modification of the web page code either from the console. Though I do notice same code you found. Another item I found is a title listing for a WNDR3400 in the code. Found that kind of odd.
From your screenshot, I see that you don't have any percentage bars in the admin page. How strange. I'm wondering if you had missed any updates on R7000? Did you keep a record of your update sequence?
I had been running the Merlin FW since 2016 when I bought the router. Until a couple of months ago, my r7000 started to randomly reboot every 3-4 days, flashing back to the stock FW (from V1.0.3.24_1.1.20 to V128) fixed the problem. 0 spontaneous reboots after that. I still had the cpu percentage bar on v128. It could be missing some of the FW in between causing the GUI issue.
