Orbi WiFi 7 RBE973
Reply

Re: nighthawk access w/o internet

jackcraigaptos
Aspirant

nighthawk access w/o internet

while my router works fine, when the internet goes down, i lose access to rtr.

when net is down i need acess most.

 

pls point me to the docs for this issue, but i was unable to find it.

 

tia..

Message 1 of 11

Accepted Solutions
IrvSp
Master

Re: nighthawk access w/o internet

On a router when connected, the router gives your devices an IP address via its DHCP. That creates the LAN. You ISP via the modem provides the Internet signal to the router and it had the WAN IP Address. You do NOT need the Internet signal to the router to access the router. Just use a Browser as mentioned above.

 

What I don't understand is "ip not responding w/o intrernet connection and login.net requiers internet for dns, right??"? Where did you get that idea from?

 

"what is the next step? if i use the yellow cable and plug it pc to lan port 1, is that the secret back door?"

 

Why do you think this is valid? There is no 'secret backdoor'? Use a BROWSER to log into the router.

 

"i did verified 192.168.1.254 responded to ping when entire lan to wan is up, ..."

 

Totally confused with that statement? I'm beging to think you are not connected to the router but you modem is also a router? What is your modem make and model? What is the IP Address of your PC?

 

 

View solution in original post

Message 10 of 11

All Replies
JoseAndres041
Luminary

Re: nighthawk access w/o internet

Once you don't have access to Internet, check your device's IP address. Ping your router and if it's replying, then you should be able to access your router.

Message 2 of 11
jackcraigaptos
Aspirant

Re: nighthawk access w/o internet

i think it might be working fine as it's performing other network ativites, but ill try it.Thx for your tme to reply

Message 3 of 11
jackcraigaptos
Aspirant

Re: nighthawk access w/o internet

i have Not been able to take that nework down to verify. i will get this done in the next 24h.

 

i did verified 192.168.1.254 responded to  ping when entire lan to wan is up, ...

Model: R8000P|Nighthawk X6S AC4000 Tri Band WiFi Router
Message 4 of 11
schumaku
Guru

Re: nighthawk access w/o internet

In case there is a ISP CPE in front of the router (e.g. a cable modem, a router, ...) which does fall-back to issue RFC1918 private IP addresses - and if this is overlapping with the router LAN subnet - the routers are (unfortunately) overly "smart" and reconfigure the local subnet to some 10.x.x.x /254

Message 5 of 11
IrvSp
Master

Re: nighthawk access w/o internet


@jackcraigaptos wrote:

while my router works fine, when the internet goes down, i lose access to rtr.

when net is down i need acess most.

 

pls point me to the docs for this issue, but i was unable to find it.

 

tia..


Are you using the Netgear Nighthawk app to access the router? If so, you need Internet access.

 

If you have LAN access, use a Browser to log into the router's IP Address (or ROUTERLOGIN.NET) to reach it and login.

Message 6 of 11
jackcraigaptos
Aspirant

Re: nighthawk access w/o internet

after internet disconnect, i am unable to access router and i need to

my host env is linux/macos, and i dont use cell phone apps.

 

my apologies or taking so long to test, trip out of town.

 

what is the next step? if i use the yellow cable and plug  it pc to lan port 1, is that the secret back door?

 

there has to be a way to access this router w/o internet access.

 

suggestions? Thx!!

 

Message 7 of 11
jackcraigaptos
Aspirant

Re: nighthawk access w/o internet

ip not responding w/o intrernet connection and login.net requiers internet for dns, right??

next?? Thx tho,...

Message 8 of 11
antinode
Guru

Re: nighthawk access w/o internet

> while my router works fine, when the internet goes down, i lose access
> to rtr.

 

   What, exactly, does "lose access" mean to you?  As usual, showing
actual actions with their actual results (error messages, LED
indicators, ...) can be more helpful than vague descriptions or
interpretations.

 

> Model: R8000P|Nighthawk X6S AC4000 Tri Band WiFi Router

 

   Is that accurate?  Firmware version?  Connected to what?

 

> i did verified 192.168.1.254 responded to ping when entire lan to wan
> is up, ...

 

   What's at "192.168.1.254"?  The default LAN IP address of an R8000P
is "192.168.1.1".

 

> after internet disconnect, i am unable to access router [...]


   When you do what?  "unable" is not a useful problem description.  It
does not say what you did.  It does not say what happened when you did
it.  See "As usual, [...]", above.

 

> what is the next step? [...]

 

   Explain what you're doing, and what happens when you do it?

 

> [...] if i use the yellow cable and plug it pc to lan port 1, is that
> the secret back door?

 

   Huh?  Which "the yellow cable"?  Where is it connected now?  Why

would you need a "secret back door" to anything?

 

> there has to be a way to access this router w/o internet access.

 

   Visit http://netgear.com/support , put in your model number, and look
for Documentation.  Get the User Manual.  Read.  If it were impossible
to communicate with a router until you have an Internet connection, then
how could anyone configure a new router?

 

> ip not responding w/o intrernet connection [...]

 

   I don't know what that means to you.  "IP" = Internet Protocol.  See
"As usual, [...]", above.

 

> [...] and login.net requiers internet for dns, right??

 

   No, using "routerlogin.net" does not require Internet access.  A
Netgear router should handle such a reference locally.

Message 9 of 11
IrvSp
Master

Re: nighthawk access w/o internet

On a router when connected, the router gives your devices an IP address via its DHCP. That creates the LAN. You ISP via the modem provides the Internet signal to the router and it had the WAN IP Address. You do NOT need the Internet signal to the router to access the router. Just use a Browser as mentioned above.

 

What I don't understand is "ip not responding w/o intrernet connection and login.net requiers internet for dns, right??"? Where did you get that idea from?

 

"what is the next step? if i use the yellow cable and plug it pc to lan port 1, is that the secret back door?"

 

Why do you think this is valid? There is no 'secret backdoor'? Use a BROWSER to log into the router.

 

"i did verified 192.168.1.254 responded to ping when entire lan to wan is up, ..."

 

Totally confused with that statement? I'm beging to think you are not connected to the router but you modem is also a router? What is your modem make and model? What is the IP Address of your PC?

 

 

Message 10 of 11
jackcraigaptos
Aspirant

Re: nighthawk access w/o internet

the posed queries identified my problem. wrong ip.

 

firmware V1.4.1.42_1.3.4

 

routerlogin.net did resolve locally.

 

further my 'failed access' was something i wasnt expecting to work.

 

regadrless, my underlying issue is router access when the internet goes down.

 

again my apologies, i appreciate your understanding

Message 11 of 11
Top Contributors
Discussion stats
  • 10 replies
  • 2062 views
  • 0 kudos
  • 5 in conversation
Announcements

Orbi WiFi 7