mr60 dhcp not working

[dbshane]

Same issue here. Default SSID works fine after resetting, but after changing SSID, DHCP doesn't work. Older firmware does seem to work (1.0.6.102), but I had to update the firmware to finish up the setup. Now I hate this router so much.

[FURRYe38]

What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Be sure your using a good quality LAN cable between the modem and router. CAT6 is recommended. 

Be sure to factory reset the MR and setup from scratch. 

I recommend changing the DHCP pool size to .100 thru .200 as well. 

I've not seen this on my MK63 system with v.132 loaded....I change SSIDs some what frequently.

[dbshane]

Thanks. It's not the cable. I downgraded to 1.0.6.102 and reset the router without internet cable. Now everything works.

[FURRYe38]

Next time, factory reset the system and setup from scratch after updating FW. 

Recommend setting the default DHCP IP address pool range to the following after applying and a factory reset: 192.168.#.100 to 192.168.#.200