NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
Ethernet Port link aggregation
I've been trying th Ethernet Port link aggregation & the 2.5 gig Multi gig port options. When trying the aggregation on mhy ReadyNAS 214 it Slows my web browsing & File access WAY DOWN!! When tryi...
To be more specific, for your setup, I would recommend the following.
- Enable Ethernet port aggregation on the RAX200 and connect ports 1 and 2 to the 2 Ehternet ports on the NAS (having its Ethernet aggregation enabled as well) (usually the "new bond" setting in the network settings tab of the readyNAS and it will need to bond using layer 2+3). Many ReadyNAS devices will not auto detect a link aggregation, thus it has to be enabled in the network settings, otherwise it will just use one or the other port but never both at once.
- Using either Ethernet port 3 or 4 of the router, connect it to your 16 port gigabit switch.
- For the multi-gig port, check if your main PC has a 2.5GbE or better Ethernet port, if not, then buy a NIC such as an RTL8125 based one, the prices fluctuate a lot, but on a good week, you can find some in the $12-15 range, and on a bad week, they can be in the $25 range). You will then connect the multi-gig port to your main PC so that it will have the full 2Gbps from the NAS when performing backups and other transfers.
- For your WiFi clients, your main laptop should have a good 802.11ax WiFi adapter, if needed, upgrade to an Intel AX200 WiFi adapter (typically around $17-$19), of it you want to eventually move to the 6GHz band, then the Intel AX210 which will go for about $25-$30. If in the same room as the router on the 5GHz band, you will get around 1.8Gbps real world throughput, and often depending on the building materials and room size, you can still hold over 1Gbps even 1-2 rooms away.
HEY.. I just mentioned my R8500 router..
Would hooking it up to the 2.5g port give me better port access & speeds
over the Netgear Switch?
For some reason my HP printer MUST be plugged into my router instead of the switch
for my printer to recognize a connection.
If I used the printers Wifi .. it takes 30-90 seconds for it to start printing which I HATE !
For the multi-gig port, tyou will only get a speed benefit is both endpointsa are multi-gig. for example, if you have a switch with a 2.5GbE uplonk, then it will get a speed benefit from being connected to the multi-gig port, but if your switch has only 1GbE ports, then connecting it to the 2.5GbE port on the router will not offerany benefit as the PHY rate will still be 1GbE.
In your case, the GS116NA will not benefit from being connected to the multi-gig port.
Sorry, lots of typos.
Anyway, in the case of uusing the multi-gig port, you will only get a benefit if the device connected to it is a 2.5GbE or higher device. This means any device with 1GbE only ports, as well as ones like the NAS which use 2 1GbE ports that can be teamed via LACP, will not benefit from the multi-gig port.
This is why to get the highest overall performance from the NAS, will be to use the port aggregation for the 1 1GbE ports for the NAS, and then the 2.5GbE port for a multi-gig capable deivce, and then a basic 1GbE port for the switch since all of its ports are 1GbE, and will not benefit from a faster port for its uplink.