NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
RBR850/RBS850 4.6.3.9 Firmware problem
RBR850 in AP mode After updating to 4.6.3.9 (rbr850 and rbs850 s) lost CONNECTION (wireless) to my two satellites (RBS850). Tried wired (backbone), works. Switched to router mode all fine (wireless a...
- And xcelebric on this forum
And xcelebric on this forum
As for the auto update, my rbr850 is on AP mode behind a pfsense router and I have blocked internet access to the rbr850
Good to hear.
I'll check my system out today and see if this happens on mine. Now that I can configure the system from being in router mode. :smileywink:
Be sure to save off a back up configuration to file for safe keeping. Saves time if a reset is needed.
https://kb.netgear.com/000062080/How-do-I-back-up-the-configuration-settings-on-my-Orbi-WiFi-System
Enjoy.
Xmk123 wrote:
As for the auto update, my rbr850 is on AP mode behind a pfsense router and I have blocked internet access to the rbr850OK, got mine set up in AP mode (v4) behind a D-Link router with it's wifi radios disabled.
RBR set for a static .85 IP address.
RBS are both wireless connected and have a reserved IP address ON the D-Link router.
Manual channels 1 and 40. CTS 2347, 40Mhz only, Guest Network disabled.
Wired speeds thru RBR in AP mode to D-Link router to CAX80 modem:
I'll let this run for a couple of days and see how it goes...
