NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

th3w01f's avatar
th3w01f
Apprentice
Oct 23, 2016

Connected devices with 1.3.0.12

I've run into an issue since upgrading to the new firmware.

 

1. Devices that were being recognized previously are now showing unknown.  I know it's easy enough to put a custom name but it's a PITA that I have to go back and figure out what the devices are again using the OUI.

 

2. I have two devices (Nest Protect and Withings scale) that are both connected to the orbi and communicating out to the internet with no issues but neiter is showing in the connected devices list.  I've verified that they are on the correct SSID and have a DHCP lease from the orbi scope. 

 

Anyone else seeing these issues?

Troubleshooting

1 Reply

  • peteytesting's avatar
    peteytesting
    Hero
    Oct 23, 2016

    hi

     

    yup , there are many unknown clients showing on this fw even though it was supposed to address the issue , not sure what happened there but i have reported it to the dev team

     

    also set the attached devices list back to the way it should be

     

    goto

     

    orbilogin.com/debug.htm

     

    tick the

     

    Enable advanced view of Attached Devices page

     

    then click save down the bottom

     

    then go back to the attached devices list and see if that helps

     

    pete