Do any Orbi products display the signal strength and TX/RX rate of connected client devices?

[michale65]

I was on the web management interface page of my RBR50 and looking at the "Attached Devices" page, and lamenting that so much useful information is left off this page. It would be quite useful from a troubleshooting and optimization perspective to see the RSSI, Noise, wireless standard in use (i.e. not just 5 Ghz, but is it 802.11n, 802.11ac, 802.11ax?), and the TX or RX link rate for all connected wireless devices.

Is this information available for any of the newer Orbi routers? Perhaps the Netgear Orbi Pro line gives more details along these lines?

TIA!

[plemans]

None of the standard ones do. 

Not sure about the pro versions. I have a SXR30 setup but it isn't hooked up right now and I'm currently running 3x networks so not sure when I"ll get a chance to connect it back up to check