Firmware 2.2.1.210 released as of 10/3/18

Do you have Daisy chain enabled or disabled with in your UI?

Glad yours is working.

Enjoy. 

@Crestviewdoc wrote:

I have been following this thread and was dreading the update.  My system is a simple setup of a router on level 1 of the house and a satellite on level 2.  

 

I was updated automatically on Saturday and was unable to connect to the internet after the update.  I then powered off the router and satellite.  I rebooted the satellite and when I was able to connect to the internet a few minutes later I then plugged in the satellite.  Since then the system  is perfect.  I have both 2.4 and 5g connected with approximately 9 evices connected, 8 wireless and 1 wired printer connected directly to the router. Everything is working flawlessly.  

 

Under the old firmware I was disconected randomly from the internet, especially (as I work from home) when I was connected to my firm's VPN.  Note that these disconnects never happended while connecting to a non-orbi router system.  It was definitely an Orbi problem as has been documented by manhy other users.  

 

Today is the first day back at work and after 2 hours I have (Thank G-d) not experienced any disconnects.  I will report back after the work day concludes with an update.  

 Daisy chain is enabled.